0HP Modules are passive circuits you can use to add utility without adding another module!
Dont let the name fool you, this module is quite a bit more than just an envelope. Patch in a gate and your output will behave as a normal sustain- release envelope, staying high while the gate is high and slowly decaying once it goes low. Patch in audio and you have an envelope follower, extracting amplitude data from whatever signal is coming in. Patch in any positive control voltage and you have a slew, adding glide whenever the incoming voltage falls. All three modes boast voltage control over the release/ response time and can use the on board input mult to either daisy chain multiple envelopes or to extract amplitude data from an audio input and then send the audio somewhere else. Possibly the most useful 0HP module yet!
Whether you need some extra utilities for your studio behemoth or you need to save space on the road, 0HP gives you options. These modules come as a small circuit board mounted to a colorful piece of laser cut plexiglass, with a small chance to get one of our fabulous rare colors.
DISCLAIMERS:
Since the modules are passive, some signal loss and distortion should be expected. The user is expected to keep cables away from the top of the circuit board. While in 99.9% of cases an accidental short circuit is not an issue, Mystic Circuits, Eli Pechman or any of our retailers assume NO RESPONSIBILITY for modules that are accidentally damaged by doing so. This expectation follows same logic as not plugging an output into another output or touching your cables to the panels, which are common safety practices expected to be followed by the end user.