Flexshaper

Klavis
$149.00
CV-controlled voltage mapper and waveshaper - perform transfer functions on CV or audio sources for clipping, frequency multiplication and wavefolder like effects, and use voltage to transform existing CV into new shapes! Insert an audio rate oscillator and bend into all new shapes, or insert a CV source to turn it into a different but related wave

Flexshaper is a deep module but also deceptively simple. Use the gain knob to set the incoming CV level, including to a clipping point to add harmonics. Ceiling and floor knobs set the minimum and maximum voltage output level, rounding out sources that approach the ceiling and floor rather than clipping. Halfway knob sets the midpoint between the floor and ceiling, and mid up and mid down control the response to those points. Each of these parameters can be modulated, including at audio rate, for huge waveshaping possibilites at audio rate or extreme transfer function bending for CV signals!

Features:

  • Process from DC to full audio range
    br>
  • Unipolar/bipolar input mode switch
    br>
  • Nominal & clip level LEDs
    br>
  • Output signal LED
    br>
  • Input gain setting for nominal level setting, allows clean flat clipping when overdriven
    br>
  • Five manual voltage mapping potentiometers
    br>
  • Five CV control of the voltage mapping points
    br>
  • Simultaneously active unipolar and bipolar outputs
    br>
  • Firmware update via a simple audio file
    br>
  • Compact and skiff-friendly module
    br>
Specifications:

6hp
6 mA +12V
7 mA -12V
32 mA 5V
21 mm deep

Flexshaper Manual