Multimode Envelope

WMD
$229.00

The WMD Multimode Envelope is our take on the classic ADSR. It offers expanded controls, multiple logic modes, and voltage control with the expansion module. This is the most powerful envelope ever designed for eurorack, capable of extremely precise tight an snappy shapes or extreme alternative shapes. Expander allows voltage control over envelope stages

Features:

  • Computer Controlled Circuitry
  • Analog Envelope Generation
  • Segment Time: 200µS to 4 minutes
  • Variable Segment Shape/Curve
  • Doepfer Standard 0-8 Volt Output
  • Gate & Envelope Strength LEDs
  • Multiple Modes of Operation
  • Full Swing Output
  • Inverted Full Swing Output
  • Manual Gate Button

Envelope Stage modes:

  • ADSR - This is the classic East Coast envelope shape. Upon a Gate input (key down), the envelope opens, then closes to the sustain level. When the gate is off (key up), the envelope releases to ground. To use as an ASR envelope, turn the Sustain fully CW and Decay will be ignored.
  • AR - This is the classic West Coast envelope shape. Upon a trigger input, the envelope opens with the Attack control, peaks, and then falls with the release control. It is triggered instead of gated and will not sustain.
  • ADR - The ADR is a trigger mode that will not sustain. Instead, at the sustain point, Decay transitions instantly to Release, allowing you to change shapes or speeds in the middle of the falling action.
  • ADSAR - This gate mode attacks, decays and sustains like a normal ADSR. After the gate is released (key up), the envelope will attack again and then release. This gives you an accent on key up.
  • ADAR - This trigger mode attacks, then decays until reaching the sustain level, then attacks again and releases.
  • ADSRst - ADSR Step Through mode runs one segment at a time as triggered. This mode causes sustain after each segment runs. After attack, it will sustain at 8 volts. After decay it will hold at the sustain level. After release, the cycle is finished and 0 volts will be output. Each segment must be complete before another trigger is recognized. This mode requires three triggers per cycle.
  • ADSARst - This is similar to ADSRst, but with a second attack after the decay. This mode requires four triggers per cycle.
  • ADRcy - This mode will cycle automatically after release is compete. It can be an AR cycling envelope by setting the sustain level to maximum. Decay will transition to Release at the sustain point. A trigger or gate will reset to the attack segment.
  • ADARcy - This self cycling mode works just like ADRcy, but will attack again from the sustain point after the decay segment. A trigger or gate will reset to the attack segment.

Specifications:

8HP
49 mA +12V
27 mA -12V
0 mA 5V
28 mm deep